相关文章

直饮水设备讲解纯净水设备软化安装步骤

来源网址:

1、首先要做到保证罐体水平ο冉树脂罐。盐罐就位于坚实的基础上。

1, the first thing you need to do to ensure the level first resin tank. The salt in the solid foundation.

2、然后将软化水设备把下布水器牢固安装在中心管底端。中心管上端低于罐口0.5mm处截断并导角,再用胶带封住中心管口 以防树脂漏入。

2, and then the water softening equipment put under water distributor firmly installed in the center of bottom. The center pipe is provided below the tank mouth 0.5mm truncation and lead angle, and then tape the center nozzle to prevent resin leakage into the.

3、将树脂均匀地装入树脂罐中。取下中心管的封口胶带,将中心管上部及树脂罐端面用水冲洗并擦干净 中心管及控制器密封圈处涂上硅油。

3, the resin evenly into the resin tank. The sealing tube center under the tape, the center pipe and the upper end surface of resin tank water rinse and clean the central tube and the sealing ring is coated with silicone oil controller. Exergy

4、将上布水器安装到控制阀上 然后将中心管从上布水器内插入到控制阀内。小心地沿顺时针方向转动控制阀 直至旋紧在树脂罐接口上(或用法兰连接固定)一定要确保中心管插入阀体。下布水器与中心管必须严密 注意ι喜妓器与控制阀、中心管。防止树脂跑出。中心管与控制阀必需严密不漏水 否则会出现窜硬水现象。

4, the water distributing device is mounted to the control valve and the center pipe from the water distributor is inserted into the control valve. Carefully along the clockwise direction control valve until the screw in the resin tank interface (or flange connection fixed) must ensure that the center tube is inserted into the body. Under the water distributor and the central tube must be kept a close watch on the water distributing device and control valve, pipe. To prevent the resin from. The central tube and the control valve must be tight without water leakage can appear otherwise channeling water phenomenon.